AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Member
cjpeach2000
Posts: 5
Registered: ‎07-03-2012
Message 1 of 2 (532 Views)

Automatic Reports Panel Nameplate Autocad Electrical 2013

532 Views, 1 Replies
08-09-2012 04:13 AM

Hi all,

 

Does anybody know if you can add the "Panel Nameplate" into the automatic reports? the only ones that appear are Bill Of Materials and components.

 

Basically we have multiple door layouts with different installations and locations and want to give our engraving department a list of "Everything", i know this can be done one by one then append the output files but this takes time and it seems silly no to be able to do this in one hit.

 

Any ideas would be much appreciated

 

cheers in advance

 

Chris

Contributor
psrajesh4u
Posts: 19
Registered: ‎08-13-2012
Message 2 of 2 (492 Views)

Re: Automatic Reports Panel Nameplate Autocad Electrical 2013

09-13-2012 09:09 PM in reply to: cjpeach2000

Hi,

 

When creating a panel lay out name plates can be inserted. After that if we are generating reports for panel then only you will get the total bom for a panel including din rail, name plate, enclosures etc. Using the report format set up you can use the descriptions 1,2,3 add in to report and give to engraving section with name plates standards as type A, type B, type C etc.

 

regards,

Rajesh.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.