AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Valued Contributor
tomw47
Posts: 53
Registered: ‎12-04-2003
Message 1 of 2 (71 Views)

AE2008 POWER CHECK FEATURE

71 Views, 1 Replies
01-04-2008 08:43 AM
Anyone using this feature for three phase calculations? Got a sample drawing of say two or three motors fed from a main circuit breaker/disconnect thru motor protector/starter thru motor disconnect switch to motor that actually works? Been trying to figure this out for sometime and can't get it to work and help info is vague.
Thanks in advance
*Nate Holt \(Autodesk\)
Message 2 of 2 (71 Views)

Re: AE2008 POWER CHECK FEATURE

01-07-2008 08:16 AM in reply to: tomw47
My opinion... this tool in its current form is not very sophisticated. It is
one of the features that came across in the original code when Autodesk
purchased the underlying software, but has yet to be reworked/enhanced.

wrote in message news:5812496@discussion.autodesk.com...
Anyone using this feature for three phase calculations? Got a sample drawing
of say two or three motors fed from a main circuit breaker/disconnect thru
motor protector/starter thru motor disconnect switch to motor that actually
works? Been trying to figure this out for sometime and can't get it to work
and help info is vague.
Thanks in advance
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.