AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Contributor
circuit1
Posts: 13
Registered: ‎01-19-2012
Message 1 of 2 (83 Views)

adding terminals to terminal strip editor

83 Views, 1 Replies
01-19-2012 05:48 AM

Hi,

 At the moment when i add a terminal to an exisitng terminal strip in terminal Strip editor or any other type of equipment such as end stops and press the Insert tab in layout preview it will insert the hole terminal strip again and not just the equipment i have added. Does anyone know how to stop it from completly adding the hole terminal strip again and only allow what i have added to that terminal strip.

 

Adrian

Contributor
ronbotkin
Posts: 20
Registered: ‎08-04-2010
Message 2 of 2 (77 Views)

Re: adding terminals to terminal strip editor

01-19-2012 08:50 AM in reply to: circuit1

When you are on the Layout Preview page you can use Rebuild instead of Insert but those are your only options.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.