AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Active Contributor
David_S_Barrow
Posts: 33
Registered: ‎05-16-2011
Message 1 of 4 (277 Views)

3D Move

277 Views, 3 Replies
05-27-2011 05:33 AM

When I'm creating a 3D panel layout in AutoCAD Electrical 2011, if I decide to move an object using the AutoCAD Move command, whilst the object is on my cursor. I change my point of view using the orbit command all the other Objects in the drawing disappear? Which makes it impossible to use any other geometry to position my object.

Valued Mentor
hardin
Posts: 700
Registered: ‎08-30-2007
Message 2 of 4 (267 Views)

Re: 3D Move

05-27-2011 01:20 PM in reply to: David_S_Barrow

If you have an object selected, it will isolate once you begin to orbit. That is a natural feature.

If you are issuing the Move command, THEN try orbit, it should continue to show everything.

Try turning Hardware Acceleration off to see if that helps.

Is the item you're moving close to the items you are moving to? If not, then maybe orbiting is just swinging the object off the screen.

 

 

Active Contributor
David_S_Barrow
Posts: 33
Registered: ‎05-16-2011
Message 3 of 4 (245 Views)

Re: 3D Move

05-31-2011 08:42 AM in reply to: hardin

I select an object to move it. I then use Shift + Middle Mouse button to rotate the display, the whole model stays visible whilst I'm rotating it but soon as I release the mouse button and shift key the rest model vanishes, leaving the part I'm moving which stays visible on the cursor. Turning off the hardware acceleration doesn't cure the problem just makes the model rotate very slowly.

Distinguished Contributor
s.wile
Posts: 140
Registered: ‎12-08-2008
Message 4 of 4 (227 Views)

Re: 3D Move

06-02-2011 06:40 AM in reply to: David_S_Barrow

Since this is more an AutoCAD question you may have better luck posting it over on the that group.

Stan Wile

Stan Wile
http://myacade.blogspot.com/
IMAGINiT Technologies
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.