after you sample offset profiles on a ground surface (say large). then when moving the design profile arnoud there is a large delay. what it's doing is probably regenerating the offset profiles. when taken away doesn't have the problem.
i don't see why this should be a problem since the offset profile has nothing to do with design profile.
2013 not sure 2012 definitely have the problem. but i doubt it will be fixed in 2013. just a rare thing probably only i use.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!