Can anyone advise me on exporting/importing pipe networks between C3D and SWMM. I have had a general look around for any recent posts without success. If it can be one and there is an older post summizing how to do this then please let me know, or if its not possible though I think it is as SWMM seems to be mentioned a bit then please also let me know.
Autodesk Storm and Sanitary Analysis (SSA) runs EPA SWMM as the hydrologic and hydraulic engine. It includes the ability to read EPA SWMM models and export to them.
Review www.autodesk.com/waterresources for more information.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!