AutoCAD Civil 3D - Stormwater

AutoCAD Civil 3D - Stormwater

Reply
Active Member
carl
Posts: 6
Registered: ‎09-14-2012
Message 1 of 2 (104 Views)

Orifice model

104 Views, 1 Replies
12-06-2012 09:12 AM

The file attached has an orifice attached to a detention basin leading to an inlet.  The flow through the orifice is .13 but it shows no flow into the inlet.  I do not understand why.  I'm not sure if I'm connecting the orifice correctly.  I've looked at the profile and run the animation and the water rises in the detention basin and it flows out but it does not run through the inlet.  I'm not sure where it goes.

 

any help would be much appreciated.

 

Thanks.

Valued Mentor
fcernst
Posts: 1,094
Registered: ‎01-07-2011
Message 2 of 2 (98 Views)

Re: Orifice model

12-06-2012 11:09 AM in reply to: carl

Yeah, it's going right on into Link-06, but not registering in the Inlet object. 

 

I simply converted the Inlet-03 object to a Junction, and then you can see the flow registering in the Junction. See below:

 

 

Capture.JPG

Fred Ernst, PE
C3D 2015
Ernst Engineering
www.ernstengineering.com
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.