AutoCAD Civil 3D - Stormwater

AutoCAD Civil 3D - Stormwater

Reply
New Member
reubencfranklin
Posts: 1
Registered: ‎11-28-2012
Message 1 of 1 (113 Views)

How do you setup a dry retention pond recovery model?

113 Views, 0 Replies
11-28-2012 08:05 AM

How do you setup a recovery analysis for a dry retention pond?

 

For instance, I have a dry retention pond that retains 8,000 cu-ft of stormwater runoff. I have to show that this volume is recovered within 72-hours via percolation. I have a site-specific geotechnical report with all the necessary parameters for the model but I'm am unsure of how to set this model up. I can run the analysis using a storge node with direct link to the boundary. However, all this is taking into account is the exfiltration rate and not the water table, porosity, confining layer, etc.. I know that aquifer conditions can be set but I'm lost on how to connect the data.

 

Any advice/help would be greatly appreciated!!

 

Reuben

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!