AutoCAD Civil 3D - Stormwater

AutoCAD Civil 3D - Stormwater

Reply
Valued Contributor
tmcmannis
Posts: 51
Registered: ‎06-19-2011
Message 1 of 5 (369 Views)
Accepted Solution

Error 211

369 Views, 4 Replies
10-03-2012 02:57 AM

Hi everyone. Im trying to run an SSA model, and everytime I do I get the message below. Any thoughts on how to solve the problem will be greatly appreciated! Thanks.

 

ERROR 211 : Invalid number * at line 10287 of [CURVE] section: Control-01 Control * *

Hello, No need to attach the model. Just check your control curves where you have defined a blank curve Control 01. Delete that curve and it will be done Thanks Amit Garg
Active Contributor
rdbrennan48
Posts: 32
Registered: ‎12-05-2011
Message 2 of 5 (347 Views)

Re: Error 211

10-04-2012 05:21 AM in reply to: tmcmannis

Could you attach a model?

Valued Contributor
tmcmannis
Posts: 51
Registered: ‎06-19-2011
Message 3 of 5 (342 Views)

Re: Error 211

10-04-2012 06:02 AM in reply to: rdbrennan48

I tried to upload and it is not a valid extension (surprising). I can email the SSA file though if you dont mind. Thanks.

Active Contributor
amit1304in
Posts: 26
Registered: ‎04-29-2010
Message 4 of 5 (337 Views)

Re: Error 211

10-04-2012 06:44 AM in reply to: tmcmannis
Hello, No need to attach the model. Just check your control curves where you have defined a blank curve Control 01. Delete that curve and it will be done Thanks Amit Garg
Valued Contributor
tmcmannis
Posts: 51
Registered: ‎06-19-2011
Message 5 of 5 (324 Views)

Re: Error 211

10-05-2012 05:19 AM in reply to: amit1304in

Thanks, that did the trick!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.