AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Message 1 of 1 (42 Views)

what are you all using for a retwall

42 Views, 0 Replies
05-30-2005 10:47 AM
Just wondering what are people using to respresent a retwall. I could not
find any daylight subassembly that could do what I wanted and was forced to
use jus a generic link subassebly.

What I wanted to do was have a daylight line that would have two instruction
sets to it

1. if the cut is greater than 2m the project at 1:5 for 2m then project to
surface at a specified grade


2. if the cut is less than 2m ignor the wall and project to the surface at a
specified grade

If someonw knows of a subassebly that will do this that would be fantastic.

Robert Howell
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.