AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Member
jtpatenaude7
Posts: 10
Registered: ‎07-27-2012
Message 1 of 4 (169 Views)
Accepted Solution

Warning - Angle is out of range

169 Views, 3 Replies
09-13-2012 02:07 PM

During an import event I get a warning message saying the Angle is out of Range.  The .fbk text below is where the import is getting hung up, the red text is the specific line.  Has anyone run into a similar error?  Any help or suggestions would be appreciated.

 

F1 VA 23211 260.52200 84.640 90.32060 "HWC1"

F1 VA 23212 260.10119 86.282 90.31600 "HWC1"

F1 VA 23213 261.27140 84.380 90.15160 "GS"

 

Thanks

 

or jsut make the angle 32' 00"

New Member
taveeeo23
Posts: 1
Registered: ‎03-29-2012
Message 2 of 4 (160 Views)

Re: Warning - Angle is out of range

09-13-2012 04:27 PM in reply to: jtpatenaude7

F1 VA 23212 260.10119 86.282 90.31600 "HWC1"

 

the angle should read 90.31599 because autocad/civil3d does not understand 60 minutes! And if you dont change it, the point will not come in. Hope this helps.

TC

Distinguished Contributor
SurveyorLee
Posts: 128
Registered: ‎12-23-2008
Message 3 of 4 (155 Views)

Re: Warning - Angle is out of range

09-13-2012 05:14 PM in reply to: jtpatenaude7

or jsut make the angle 32' 00"

Active Member
jtpatenaude7
Posts: 10
Registered: ‎07-27-2012
Message 4 of 4 (144 Views)

Re: Warning - Angle is out of range

09-14-2012 04:26 AM in reply to: SurveyorLee

Thank you!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!