AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Member
10 Posts
0 Kudos
Registered: ‎07-27-2012
Post 1 of 4
Accepted Solution

Warning - Angle is out of range

174 Views, 3 Replies
09-13-2012 02:07 PM

During an import event I get a warning message saying the Angle is out of Range.  The .fbk text below is where the import is getting hung up, the red text is the specific line.  Has anyone run into a similar error?  Any help or suggestions would be appreciated.

 

F1 VA 23211 260.52200 84.640 90.32060 "HWC1"

F1 VA 23212 260.10119 86.282 90.31600 "HWC1"

F1 VA 23213 261.27140 84.380 90.15160 "GS"

 

Thanks

 

or jsut make the angle 32' 00"

New Member
1 Posts
1 Kudo
Registered: ‎03-29-2012
Post 2 of 4

Re: Warning - Angle is out of range

09-13-2012 04:27 PM in reply to: jtpatenaude7

F1 VA 23212 260.10119 86.282 90.31600 "HWC1"

 

the angle should read 90.31599 because autocad/civil3d does not understand 60 minutes! And if you dont change it, the point will not come in. Hope this helps.

TC

Distinguished Contributor
128 Posts
9 Kudos
Registered: ‎12-23-2008
Post 3 of 4

Re: Warning - Angle is out of range

09-13-2012 05:14 PM in reply to: jtpatenaude7

or jsut make the angle 32' 00"

Active Member
10 Posts
0 Kudos
Registered: ‎07-27-2012
Post 4 of 4

Re: Warning - Angle is out of range

09-14-2012 04:26 AM in reply to: SurveyorLee

Thank you!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are you interested in helping shape the future of the Autodesk Community? To participate in this brief usability study, please click here. Your time and input is greatly appreciated!