Typically when setting up a viewport in paper space I can change the viewport type at the bottom of the properties dialog box. In 2013 the option is available, but it will always snap back to undefined. I'm sure it is a setting somewhere. Any help would be appreciated. Thanks,
Interesting... I seem to be noticing the same problem.
Guess I need to explore this and try to figure it out, since I'm supposed to be doing some training later this week in how to create P&P sheets... I hope nothing is broken in C3D 2013. (Luckily, I think we'll be using C3D 2012, and not C3D 2013...)
Interestingly, if you open a 2012 file with that viewport already set, it stays set. However, you can't change it in 2013.
Access a broad range of knowledge to help get the most out of your products and services.