AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Distinguished Contributor
RickNichols
Posts: 227
Registered: ‎12-02-2003
Message 1 of 6 (165 Views)

vertical curve labels (low and high point)

165 Views, 5 Replies
09-13-2005 03:42 PM
I've created a high point and low point label component for my vc, but they don't show up. I had question marks in their place for awhile until I set the anchor points to low and high point, and now I have nothing. Here is a screen shot showing my low point component. The high point is basically the same. Can anybody tell me what I'm doing wrong?

thanks,
rick
Distinguished Contributor
RickNichols
Posts: 227
Registered: ‎12-02-2003
Message 2 of 6 (165 Views)

Re: vertical curve labels (low and high point)

09-13-2005 03:42 PM in reply to: RickNichols
forgot the screen shot
Distinguished Contributor
RickNichols
Posts: 227
Registered: ‎12-02-2003
Message 3 of 6 (165 Views)

Re: vertical curve labels (low and high point)

09-13-2005 04:02 PM in reply to: RickNichols
Just to follow up. If I change my anchor point to something other than low point and high point, say for example anchor pvi, I get ??? at the anchor point location. But I still get nothing if I use the low and high point anchors. It's as if Civil 3d can't find the low points of my vc. Any advice?
rick
Distinguished Contributor
RickNichols
Posts: 227
Registered: ‎12-02-2003
Message 4 of 6 (165 Views)

Re: vertical curve labels (low and high point)

09-13-2005 04:05 PM in reply to: RickNichols
du! Never mind. I sure wish I could delete this whole post before anybody reads it. And I am even more humiliated. Hey administrator, why don't you save me some embarassment and remove all of this.

rick
Distinguished Contributor
mscacco
Posts: 139
Registered: ‎11-17-2003
Message 5 of 6 (165 Views)

Re: vertical curve labels (low and high point)

09-13-2005 06:26 PM in reply to: RickNichols
looks like you realized you have no HP/LP on the curve in question. As the author of the posts you should be able to edit them so they're blank, but no need to be embarrassed. Its kinda funny actually. It's be great if all technical issues were as easy to resolve.

Mark
Distinguished Contributor
RickNichols
Posts: 227
Registered: ‎12-02-2003
Message 6 of 6 (165 Views)

Re: vertical curve labels (low and high point)

09-13-2005 09:17 PM in reply to: RickNichols
Thanks Mark,

That's exactly what I realized finally. I've looked around here to see how I can edit my posts like you mentioned, but can't find anything. That' all right, maybe somebody else about to make the same mistake, will be warned by my stupid mistake.

rick
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.