Community
Civil 3D Forum
Welcome to Autodesk’s Civil 3D Forums. Share your knowledge, ask questions, and explore popular AutoCAD Civil 3D topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Value on wrong side of alignment or profile

8 REPLIES 8
Reply
Message 1 of 9
Myers
3717 Views, 8 Replies

Value on wrong side of alignment or profile

I have a corridor where I get two errors when I rebuild it. The two errors are as follows:

0+29.46': Value on wrong side of alignment or profile
0+00.00': Value on wrong side of alignment or profile

Any suggestions?
8 REPLIES 8
Message 2 of 9
NathanBee
in reply to: Myers

Yes.

Post a screenshot (preferably PNG) and version of C3D you are working with. Then someone may help you.

Otherwise all I would think you're on about is flipping a label or some such...

Nathan Bartholomew | CAD/Civil Designer | Tse Group Limited
WELLINGTON | AUCKLAND | NEW ZEALAND
A Downer EDI company.

Civil3D 2008 | SP2
Windows XP | SP2
Pentium 2.4GHz | 2GB RAM
NVIDIA Quadro FX 560 | 128MB
Message 3 of 9
Myers
in reply to: Myers

i am using civil 3d 2008
Message 4 of 9
Myers
in reply to: Myers

Here is another screen shot
Message 5 of 9
Cliff Patterson
in reply to: Myers

I've never seen that error before.

Do you have some targets set in a region covering 0+00 to 0+29.46? Maybe an incorrect target was selected (opposite side?). But usually the error would be something to like 'target not found' not 'wrong side of alignment'.

Sorry I couldn't be more help.


Cliff Patterson
Rocke & Associates
Fort Wayne, IN.
Civil 3d 2007, SP-3
Xeon 2.80 Ghz, 2.0 GB Ram
Message 6 of 9
NathanBee
in reply to: Myers

Sorry Myers, I can't be of any help either.

I searched the DGs though and it had a few other people who had this error. No solutions though. =(
Message 7 of 9
Myers
in reply to: Myers

they are actually on two different alignments. one is the alignment areound the curve in the intersection at the top of the screen while the other is the alignment around the curve in the intersection at the bottom of the screen.
Message 8 of 9
Anonymous
in reply to: Myers

Try changing the regions to start/end 0.01 after/before the ends for the 2
returns.

"Myers" wrote in message news:5867547@discussion.autodesk.com...
they are actually on two different alignments. one is the alignment areound
the curve in the intersection at the top of the screen while the other is
the alignment around the curve in the intersection at the bottom of the
screen.
Message 9 of 9

I get the same error -

Try checking the offset parameters you assigned when you made the intersection. I had my settings switched (2 different road widths) so i flipped the values and the error stopped.

Of course I'm new at this, it could have been coincidence.

 

 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Rail Community


Autodesk Design & Make Report