Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Do you have some targets set in a region covering 0+00 to 0+29.46? Maybe an incorrect target was selected (opposite side?). But usually the error would be something to like 'target not found' not 'wrong side of alignment'.
Sorry I couldn't be more help.
Cliff Patterson
Rocke & Associates
Fort Wayne, IN.
Civil 3d 2007, SP-3
Xeon 2.80 Ghz, 2.0 GB Ram
they are actually on two different alignments. one is the alignment areound the curve in the intersection at the top of the screen while the other is the alignment around the curve in the intersection at the bottom of the screen.
Try changing the regions to start/end 0.01 after/before the ends for the 2
returns.
"Myers" wrote in message news:5867547@discussion.autodesk.com...
they are actually on two different alignments. one is the alignment areound
the curve in the intersection at the top of the screen while the other is
the alignment around the curve in the intersection at the bottom of the
screen.
Try checking the offset parameters you assigned when you made the intersection. I had my settings switched (2 different road widths) so i flipped the values and the error stopped.
Of course I'm new at this, it could have been coincidence.
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")