AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Member
4 Posts
0 Kudos
Registered: ‎10-29-2012
Post 1 of 5
Accepted Solution

unknown command

386 Views, 4 Replies
10-29-2012 12:09 PM

wht do I get unknown command "aecccreatealignment" when I have civil 3d and companion land desktop?

Hi,

 

+ adding to Tatiana:

>> What software are you using?

What profile is active? If you run Civil3D with the profile "as AutoCAD" then the AECC-commands are not available.

 

- alfred -

Alumni
129 Posts
8 Kudos
Registered: ‎10-25-2011
Post 2 of 5

Re: unknown command

10-29-2012 02:04 PM in reply to: V-Rock

Hi Van,

What software are you using?

If you are getting a message like that most likely is product of a bad install, please run a reinstall of the software from the control panel.

Tatiana Machado
AEC-ENI Application Engineer
*Expert Elite*
9,800 Posts
1,210 Kudos
Registered: ‎06-29-2007
Post 3 of 5

Re: unknown command

10-29-2012 02:09 PM in reply to: V-Rock

Hi,

 

+ adding to Tatiana:

>> What software are you using?

What profile is active? If you run Civil3D with the profile "as AutoCAD" then the AECC-commands are not available.

 

- alfred -

-------------------------------------------------------------------------
Alfred NESWADBA
Ingenieur Studio HOLLAUS ... www.hollaus.at
-------------------------------------------------------------------------
New Member
1 Posts
0 Kudos
Registered: ‎09-09-2011
Post 4 of 5

Re: unknown command

10-29-2012 03:31 PM in reply to: V-Rock

Thanks I'll try both solutions when I get to work tomorrow

Member
4 Posts
0 Kudos
Registered: ‎10-29-2012
Post 5 of 5

Re: unknown command

10-30-2012 05:25 AM in reply to: Alfred.NESWADBA

Thanks Alfred! I got it going now:manhappy:

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post