Community
Civil 3D Forum
Welcome to Autodesk’s Civil 3D Forums. Share your knowledge, ask questions, and explore popular AutoCAD Civil 3D topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Trouble Consistantly Daylighting from SubAssembly to Alignment Target

3 REPLIES 3
Reply
Message 1 of 4
L3GO-Ed
5432 Views, 3 Replies

Trouble Consistantly Daylighting from SubAssembly to Alignment Target

Am struggling to pull off some corridor but the standard daylight subassembly is letting me down. It mulfunctions when I connect it to the Generic Linktoslope subassembly. In some Areas it works fine but in others it doesn't. My plan is to apply a ditch at the point where the LinktoSlope meets the ground level and to have this ditch again daylight back to the target surface.

 

any suggestions will be appreciated

3 REPLIES 3
Message 2 of 4
fcernst
in reply to: L3GO-Ed

This subassembly is confirmed defective:

 

http://forums.autodesk.com/t5/AutoCAD-Civil-3D-General/Confirmed-Defect-Daylight-Standard/m-p/430207...

 



Fred Ernst, PE
C3D 2024
Ernst Engineering
www.ernstengineering.com
Message 3 of 4
sboon
in reply to: L3GO-Ed

Use DaylightGeneral instead.  It's a little more complex but doesn't have the same issue as DaylightStandard.

 

Steve
Please use the Accept as Solution or Kudo buttons when appropriate

Steve
Expert Elite Alumnus
Message 4 of 4
L3GO-Ed
in reply to: L3GO-Ed

ehwu, atleast this clears it. So i need to think of another subassembly. thanx for the replies guys

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Rail Community


Autodesk Design & Make Report