Just wondered if there is anyone who knows how to create a transition crossfall over a distance in assembly. For example, I would like to get hardshoulder crossfall along the edge of travel lane from proposed 2.5% to tie in the existing (e.g. 1%) over 10m.
I hear there is a super elvation parameter in the alignment some where, but I never looked into it. I would create a profile to control the edge and target it in the corridor.
It's complicated, but possible.
Thanks to SteveB.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!