AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Member
wilwil02
Posts: 3
Registered: ‎05-03-2012
Message 1 of 3 (395 Views)

Transition Crossfall

395 Views, 2 Replies
05-04-2012 11:06 AM

Dear All,

 

Just wondered if there is anyone who knows how to create a transition crossfall over a distance in assembly. For example, I would like to get hardshoulder crossfall along the edge of travel lane from proposed 2.5% to tie in the existing (e.g. 1%) over 10m.

 

Regards

*Expert Elite*
Joe-Bouza
Posts: 5,188
Registered: ‎12-15-2008
Message 2 of 3 (380 Views)

Re: Transition Crossfall

05-04-2012 03:10 PM in reply to: wilwil02

I hear there is a super elvation parameter in the alignment some where, but I never looked into it. I would create a profile to control the edge and target it in the corridor.

Thank you

Joseph D. Bouza, P.E. (one of 'THOSE' People) Civil 3D 2012 & 2013
HP Z210 Workstation
Intel Xeon CPU E31240 @ 3.30 Hz
12 GB Ram


Note: Its all Resistentialism, so keep calm and carry on

64 Bit Win7 OS
*Expert Elite*
mathewk
Posts: 2,792
Registered: ‎07-09-2003
Message 3 of 3 (374 Views)

Re: Transition Crossfall

05-04-2012 03:46 PM in reply to: wilwil02

It's complicated, but possible.

http://www.civil4d.com/2012/05/transition-a-corridor-daylight-slope/

 

Thanks to SteveB.

 

Matt Kolberg
Cansel - Autodesk Division
http://www.cansel.ca/
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.