AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
*Expert Elite*
troma
Posts: 2,525
Registered: ‎05-21-2008
Message 21 of 24 (69 Views)

Re: Tieing Into Existing Berm

12-13-2012 05:55 AM in reply to: LisaPohlmeyer

Does the LinkSlopeToElevation link allow you to target a profile, or just choose a set elevation?


Credit where credit is due! Give kudos or accept as solution whenever you can.

*Pro
fcernst
Posts: 1,168
Registered: ‎01-07-2011
Message 22 of 24 (68 Views)

Re: Tieing Into Existing Berm

12-13-2012 05:59 AM in reply to: troma

Yes, so does LinkSlopeAndVerticalDeflection.

 

Capture.JPG

Fred Ernst, PE
C3D 2015 SP2
Ernst Engineering
www.ernstengineering.com
*Expert Elite*
troma
Posts: 2,525
Registered: ‎05-21-2008
Message 23 of 24 (61 Views)

Re: Tieing Into Existing Berm

12-13-2012 06:16 AM in reply to: fcernst

That would to be the way to go then.  The OP was worried:

 

 

"Lisa, good thought but the "linkslopetoelevation" want a constant elevation to project up to.  In my case, the 4:1 slope needs to continue project up until it meets the design profile elevation at that particular cross section."

 

but if you can target a profile, then start at the top of berm with this link, target the design profile at 4:1

 


Credit where credit is due! Give kudos or accept as solution whenever you can.

*Pro
fcernst
Posts: 1,168
Registered: ‎01-07-2011
Message 24 of 24 (57 Views)

Re: Tieing Into Existing Berm

12-13-2012 06:36 AM in reply to: troma


Oh yeah...she had it nailed down from the get-go dude...

 

 

Fred Ernst, PE
C3D 2015 SP2
Ernst Engineering
www.ernstengineering.com
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.