Three profiles on a plan and profile sheet

[fcernst]

What is the most current Civil 3D workflow recommendation from Autodesk, for people who are required to show and label three profiles: centerline, left and right gutter flowlines; on a plan and profile sheet for drainage review? The gutter flowline profiles are required to show their true longitudinal grade.

Not looking to bother anyone for a lot of detail here in this venue, can figure out the details later. Just looking for the main salient steps at the conceptual level.

[GZE]

I would create alignment and profile from corridor guter flowlines and superimpose in main alignment pr-view, you can also install SA contry kit

[fcernst]

Thanks

Does the superimposed profile contain the true longitudinal grade information for labeling?

Sorry what is SA country kit?

[GZE]

SA -South Africa country kit

[Joe-Bouza]

Hi Fred, I don't think that nut has been cracked. Its been bouncing around for a while.

Super Impose gets it there but the station calcs now off baseline