Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I find it absurd that AutoCad C3D doesn't have a vehicle sweep routine built in to the design software. This is as basic to roadway design as superelevation is to horizontal curvature. Am I missing something? Is it there, or is there some reason it is not there? Very frustrating.
Buying third party software such as AutoTurn or Pathplanner R4 seems ridiculous.
I found a much cheaper solution for vehicle turn paths! Rob Gadbaw over at CGS had a great add-on application for vehicle turn paths that was less than $600.00 I would check them out at http://www.cgsplus.com
I found a much cheaper solution for vehicle turn paths! Rob Gadbaw over at CGS had a great add-on application for vehicle turn paths that was less than $600.00 I would check them out at http://www.cgsplus.com
Works for me on R2012 - R2014. Give them a try...
That looks like a great program, but the cost is much higher than $600. The initial license is $1,295 and then a subscription being $395.
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")