Nothing has been promoted like you explained and everything has a shortcut icon. I have attached the plan view and profile to show what i am talking about. In the plan view the area clouded was added to my surface but on the profile that area is not being drawn.
Does the clouded area show up in plan in the profile drawing?
Try deleting the profile and drawing it again. Not the whole profile view, just the one profile.
Credit where credit is due! Give kudos or accept as solution whenever you can.
If you select the profile do you see a autocad grips on all of the segment endpoints? If so this indicates that the profile lost it's link to the surface and you would need to resample the surface profile.
Yes the clouded area shows up in the profile drawing. Tryed drawing just the one profile with no luck. I also tryed drawing a whole new profile from scratch and that seemed to work. really weird and frustrating.
GOT IT! I keep the properties thingy open. If you select the surface in your profile view, there is an option to choose either static or dynamic updating. Whaalaa!!
What version of Civil 3D are you using? I sounds like the same issue we had with 2013 and 2014SP1. We would dref the surface and dref the alignment and then sample the drefed surface (not dref the surface profile). We had to toggle the profile from dynamic to static and back again to get the profile to update when the surface changed to get it to update. At first is seemed like drawings that were created with older versions (2011) of C3D and saved as 2013. 2014 SP2 appear to have fixed this iussue.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!