AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Contributor
eyescast
Posts: 37
Registered: ‎07-09-2011
Message 1 of 3 (209 Views)

surface profile not shown in the profile view

209 Views, 2 Replies
11-28-2012 06:16 PM

Hi,

 

Attached are survey points that created the surface of a road embankment portion that caved-in. The road is very near a reservoir  shoreline. 

 

1. How can a surface profile be produce? I/'ve use line to change it into an alignement and then create a proile , then a 

profile view. But the the surface profile is missing. 

2.the points having higher elevation are the  top edge( road level) of the cave-n . A few few shots were take before the shorline elevations.

 

2. What the best way to come up with the rock volume to fill the cave-in given this surveying points., Also the shoreline elevation will be lowered some more while work is being done since the fill is not allowed to fall in the reservoir. 

 

Thanks. Appreciate the help the forum is doing .

 

joe.

*Expert Elite*
tcorey
Posts: 2,761
Registered: ‎12-18-2002
Message 2 of 3 (193 Views)

Re: surface profile not shown in the profile view

11-29-2012 06:35 AM in reply to: eyescast

Pick the profile view object, right click, select Profile View Properties.

 

One the Profiles tab be sure there is a check mark next to your surface.

 

If the surface profile is not there, pick the alignment in plan view. On the ribbon, find Surface Profile and create a surface profile. It will be added to the profile view automatically.

 

Regarding how to calc earthworks. You can create a surface using the collapsed bank and another that shows the surface with the bank in place. Create a third surface that is a TIN Volume Surface which compares the other two. In the Surface Properties of that surface, go to the Statistics tab and expand Volume.

Tim Corey, Owner
Delta Engineering Systems
Redding, CA
Autodesk Authorized Value-Added Reseller
*Expert Elite*
troma
Posts: 2,525
Registered: ‎05-21-2008
Message 3 of 3 (182 Views)

Re: surface profile not shown in the profile view

11-29-2012 10:15 AM in reply to: eyescast

You can also check the profile style is turned on, and check the layers are on.


Credit where credit is due! Give kudos or accept as solution whenever you can.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.