AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
New Member
srb22
Posts: 2
Registered: ‎03-14-2012
Message 1 of 1 (96 Views)

Surface edit / data reference

96 Views, 0 Replies
03-14-2012 01:28 PM
I have surface created from an xyz point file, today I had to extend the surface but the new data was in a .asc file. I edited the surface definition by adding dgm...no problem, however the surface was data referenced into another drawing (B) and post edit drawing (B) won't open? I went back and deleted the new data and then drawing (B) was ok. Can anyone point out where I'm going wrong ??
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.