AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Valued Contributor
907Trekker
Posts: 56
Registered: ‎10-28-2009
Message 1 of 2 (1,018 Views)

Surface Cross Section Report from Sample Lines

1018 Views, 1 Replies
03-05-2011 02:09 PM

Hello,

 

Is anybody aware of a command, report, or program that would allow me to generate a report showing the following:

 

  • Station of sample line
  • Offset and elevation at all breakpoints along the sampled tin surface

Basically just a report containing the same information that is plotted in a section view when sampling a surface.  Please note that the surface I am interested in is made up of numerous survey points that are not necessarily on station.  The surface is not generated from feature lines. 

 

Thanks,
Mark

 

 

Valued Contributor
907Trekker
Posts: 56
Registered: ‎10-28-2009
Message 2 of 2 (937 Views)

Re: Surface Cross Section Report from Sample Lines

03-28-2011 12:31 PM in reply to: 907Trekker

I did figure this out (completely by chance).  If you are looking for this it is under Corridor -> Feature Line Reports -> Then you select the "Surfaces" radio button and it will give you the data you need.

 

I couldn't figure this out because in my case there was no Corridor, and I really felt this would be under something else.

 

I see that 80 people have looked at this post so hopefully this helps somebody!

 

Mark

 

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.