AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Contributor
Aistis88
Posts: 41
Registered: ‎01-28-2013
Message 1 of 2 (153 Views)

Subbassembly composer codes and targets , problem in corridor parameters

153 Views, 1 Replies
09-09-2013 10:52 PM

I create assemblys using "Autodesk subassembly composer ". I import them and build a corridor from them.   If i make corridor from one assembly with "pave offset target" and other "target to surface" i have to set those targets in corridor. Problem is  - if that corridor have like for example 10 regions, i have to set same targets for  all regions and its is quite difficult , couse usually i have like 2-3 assemblys with different construction but the same targets and like 20-30 regions , so if my corridor  must target pave offset i have to set that SAME target for the right and for the left side 30x2 = 60 times.

 

Is there any possibility that could remove this misery ?

 

Distinguished Contributor
nilesh33
Posts: 103
Registered: ‎07-08-2009
Message 2 of 2 (120 Views)

Re: Subbassembly composer codes and targets , problem in corridor parameters

09-10-2013 02:34 AM in reply to: Aistis88

Hi,

 

It's same procedure even if you are using autodesk stock subassemblies.

But you can set "Surface Target" for all regions at once by selecting "Set Targets All Targets" in corridor properties.

(Select option click here to set all)

 

For offset targets, I would suggest you to create one small region with all offset targets and apply this region for full length. Then split this region into smaller once according to your assemblies.

 

Hope it will help you.

 

Regards,
Nilesh J
Civil 3D 2012, SAC
16 GB Ram 64 Bit Win7
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.