Start station in blanck for band profile.

[joantopo]

I have a trouble in 2015 release but I think that it already happened in 2014.

In profile bands don´t appear start station labels.

In only happens if "Profile 1" is from Surface Profile. I have tried with other Surface Profile and I have the same problem.

I Think, that sometimes also happens for end stations.

If "Profile 1" is Layout profile(design profile) I have no problem never (start stations and end stations always appears in bands profile).

[Anonymous · Accepted solution]

Hello my friend
I just do not know why this happens
Anyway
Go to profile view properties
Station tab swith to ( use sepecified range ) and manually enter START & END stations with following instructions
Instead of 0+000 for instance change it to 0.01
And and vice versa for end station say 15+475.23 ( hightlight .23 and lower it a bit like .2 or a bit smaller )
It works it out

[joantopo]

Yes, I think that it´s the only solution.

 I had already read something about that.

Thanks.

[Anonymous]

Good Luck