Is there a way to have the highest elevation appear first and lowest elevation last? Also is there a way to have the table show acreage rather than sq ft? This is for a reservoir where we proposed a floating barge water intake to pump water to a treatment plant. Normal pool is 2488.10. Lowest elevation is 2430. The table shows 2430 first, then increments down to 2488 at 1 foot increments. Lastly, how would I get the table to show .10 (pool is 2488.10), or would this be math I need to figure and somehow manipulate the table to add manually? .10 doesn't seem like a lot but over a large area it is.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!