Community
I resolved the zig zag feature line as displayed in my earlier post. In my assembly I had attached and outside super lane to the edge of overlay and the sub properties was defaulting to "crown point inside" : set to yes. I set to No and all is fine.
in case anyone wanted to know
Thanks, Joe
Joe Bouza
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")