Good morning, boardmembers.
I received a file from another office which had a split profile. The only issue that my project manager and I have with it is that the profile lines themselves run from station limit to station limit, and therefore the profile lines run through the vertical (elevation) numbers. Is there a way to adjust the vertical (elevation) grid marks to clean this up?
I've attached a picture of how it looks now. Thanks in advance to all who can help.
Its a workaround, but I have used it before. Create a wipeout and use draw order to bring the profile view to the front and send the profile to the back, so that the wipeout is in the middle.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!