Is anyone else having problems with the spanning pipe labels in profile. Sometimes it works fine and others not at all. It will let me pick the two structures at each end and highlights the pipes, but then it will not let me pick the pipe to place the label on.
Its only happened so far in 2 drawing. Labels the wrong length for curved pipes too.
When you use this command in Civil 3D, you can't even select pipes at all. It just plain does not work. One of my customers sent me their file and I could easily reproduce. I may open a separate discussion item about this. I would attach the file, but it belongs to my client.
Civil & Technical Support Manager
CADD Microsystems, Inc.
Credit where credit is due! Give kudos or accept as solution whenever you can.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!