AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Member
scott
Posts: 8
Registered: ‎10-15-2008
Message 1 of 3 (226 Views)

Single Errant Corridor Section in Cul De Sac

226 Views, 2 Replies
02-06-2013 02:56 PM

See the attached image.  I have a single corridor "section" that extends from the 'tip' of my cul-de-sac back to the start of the alignment.  Any thoughts on what is causing this?

 

I scoured the group before posting and didn't see anything quite the same.

 

Would it have something to do with the corridor line being parallel to the alignment?

 

Thanks.

*Expert Elite*
sboon
Posts: 2,226
Registered: ‎11-08-2005
Message 2 of 3 (201 Views)

Re: Single Errant Corridor Section in Cul De Sac

02-06-2013 08:31 PM in reply to: scott

Would it have something to do with the corridor line being parallel to the alignment?


More than likely.  Can you delete the offending corridor section?  Another option may be to edit the centerline alignment to add a very small circular segment at the center of the culdesac, so that the corridor can target it properly.

Active Member
scott
Posts: 8
Registered: ‎10-15-2008
Message 3 of 3 (185 Views)

Re: Single Errant Corridor Section in Cul De Sac

02-07-2013 06:50 AM in reply to: scott

I ended up splitting the baseline into two regions to solve this.  I created two regions with a 0.1' gap to avoid the point where the alignment was parallel to the offending corridor section.  It 'worked' but might not be the preferred solution.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.