AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Member
wrdesign
Posts: 3
Registered: ‎05-06-2011
Message 1 of 4 (1,145 Views)
Accepted Solution

Setting Default Label Style- Civil 3d 2013

1145 Views, 3 Replies
02-23-2014 05:35 PM

I am attempting to label top and bottom curb in my civil drawing.  I created a new label style in toolspace under points label styles. I created it with an expression to show a 6" curb. 

 

My new label look like this in the label style composer.

TC: 100.00

BC:  99.50

 

However, I'm unsure where to set it as the default label style when I start labeling top and bottom of curb.   At this time when I use the label spot elevation command I still get the default single line like shown below.

 

100.00

 

Any help would be appreciated.

Set the default here:

Settings Tab of Toolspace> Surface>Commands>AddSurfSpotElevLabel>Default Styles>Surface Spot Elevation Label Style>

*Expert Elite*
Jay_B
Posts: 2,432
Registered: ‎09-15-2010
Message 2 of 4 (1,139 Views)

Re: Setting Default Label Style- Civil 3d 2013

02-23-2014 05:48 PM in reply to: wrdesign

Set the default here:

Settings Tab of Toolspace> Surface>Commands>AddSurfSpotElevLabel>Default Styles>Surface Spot Elevation Label Style>

Jay

C3D 2014 SP2
Win 7 Professional 64 Bit
*Expert Elite*
Jay_B
Posts: 2,432
Registered: ‎09-15-2010
Message 3 of 4 (1,136 Views)

Re: Setting Default Label Style- Civil 3d 2013

02-23-2014 05:51 PM in reply to: wrdesign

So is this a Surface Spot Elevation or are you creating Points and using a Point label?

 

Jay

C3D 2014 SP2
Win 7 Professional 64 Bit
Member
wrdesign
Posts: 3
Registered: ‎05-06-2011
Message 4 of 4 (1,079 Views)

Re: Setting Default Label Style- Civil 3d 2013

02-24-2014 01:33 PM in reply to: Jay_B
Spoiler
Thanks, I was creating my label in the point label style instead of the spot elevation label style.  Figured it out.
Spoiler
 
Spoiler
Thank You
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.