Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
All, I have created a drawing with cross sections. When I open the drawing the material table shows up below the section view instead of where I placed it. If I update the group the tables go back to where they should be. The problem is when I publish them using SSM the tables show up below the view , where they are when I open the drawing. Does anyone know a solution for this. It would be very time consuming to plot each sheet individually. Thanks, Dave