AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Contributor
37 Posts
0 Kudos
Registered: ‎09-12-2004
Post 1 of 4
Accepted Solution

section not coming right

134 Views, 3 Replies
10-08-2013 07:22 PM

The cross section at the culdesac is not coming right (attached). Instead of a gradual slope, i get a drop near the centerline. I am targeting to the CL alignment and profile. Have anyone come across such situation?. Why is it happening.

 

Thanks

It looks like you may have the wrong profile showing. In the properties for your profile make sure you have the correct surface selected

 

Nik-D

I concur. triple check your targets

You guys were right. The problem was the prop. profile was little shy of the alignment. It works fine now. Thanks for your help.

Mentor
224 Posts
10 Kudos
Registered: ‎09-10-2012
Post 2 of 4

Re: section not coming right

10-09-2013 04:04 AM in reply to: om_gc

It looks like you may have the wrong profile showing. In the properties for your profile make sure you have the correct surface selected

 

Nik-D

*Expert Elite*
5,255 Posts
326 Kudos
Registered: ‎12-15-2008
Post 3 of 4

Re: section not coming right

10-09-2013 04:06 AM in reply to: om_gc
I concur. triple check your targets
Thank you

Joseph D. Bouza, P.E. (one of 'THOSE' People) Civil 3D 2012 & 2013
HP Z210 Workstation
Intel Xeon CPU E31240 @ 3.30 Hz
12 GB Ram


Note: Its all Resistentialism, so keep calm and carry on

64 Bit Win7 OS
Active Contributor
37 Posts
0 Kudos
Registered: ‎09-12-2004
Post 4 of 4

Re: section not coming right

10-09-2013 05:33 AM in reply to: om_gc

You guys were right. The problem was the prop. profile was little shy of the alignment. It works fine now. Thanks for your help.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post