AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Distinguished Contributor
MonkeyTrainer
Posts: 156
Registered: ‎11-30-2007
Message 1 of 3 (226 Views)
Accepted Solution

section editor view width

226 Views, 2 Replies
11-14-2012 06:40 AM

when i get into my section editor, the view is zoomed out too far. is there a way to change the width of this view? i looked in display options, but may have skipped over the solution.

 

thanks.

There should be an option for default zoom scale or factor.  Make sure that is set to 1 and see what happens.  Something else to keep in mind is that the default view is supposed to include the extents of the corridor section.  If you have a targeting error or a bad elevation far away from the baseline then the software will try to show that.

*Expert Elite*
sboon
Posts: 2,204
Registered: ‎11-08-2005
Message 2 of 3 (220 Views)

Re: section editor view width

11-14-2012 08:15 AM in reply to: MonkeyTrainer

There should be an option for default zoom scale or factor.  Make sure that is set to 1 and see what happens.  Something else to keep in mind is that the default view is supposed to include the extents of the corridor section.  If you have a targeting error or a bad elevation far away from the baseline then the software will try to show that.

Distinguished Contributor
MonkeyTrainer
Posts: 156
Registered: ‎11-30-2007
Message 3 of 3 (218 Views)

Re: section editor view width

11-14-2012 08:22 AM in reply to: sboon

ok, you're right. i looked over that and found it in "view/edit options". thanks.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!