AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Distinguished Contributor
MonkeyTrainer
Posts: 155
Registered: ‎11-30-2007
Message 1 of 3 (225 Views)
Accepted Solution

section editor view width

225 Views, 2 Replies
11-14-2012 06:40 AM

when i get into my section editor, the view is zoomed out too far. is there a way to change the width of this view? i looked in display options, but may have skipped over the solution.

 

thanks.

There should be an option for default zoom scale or factor.  Make sure that is set to 1 and see what happens.  Something else to keep in mind is that the default view is supposed to include the extents of the corridor section.  If you have a targeting error or a bad elevation far away from the baseline then the software will try to show that.

*Expert Elite*
sboon
Posts: 2,180
Registered: ‎11-08-2005
Message 2 of 3 (219 Views)

Re: section editor view width

11-14-2012 08:15 AM in reply to: MonkeyTrainer

There should be an option for default zoom scale or factor.  Make sure that is set to 1 and see what happens.  Something else to keep in mind is that the default view is supposed to include the extents of the corridor section.  If you have a targeting error or a bad elevation far away from the baseline then the software will try to show that.

Distinguished Contributor
MonkeyTrainer
Posts: 155
Registered: ‎11-30-2007
Message 3 of 3 (217 Views)

Re: section editor view width

11-14-2012 08:22 AM in reply to: sboon

ok, you're right. i looked over that and found it in "view/edit options". thanks.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.