AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Member
johnmeyers
Posts: 9
Registered: ‎06-22-2012
Message 1 of 2 (118 Views)

renumber sheet set through sub sets

118 Views, 1 Replies
10-08-2013 02:02 PM

Does anyone know of a way to renumber an entire sheet set without having to stop at each subset?  Currently, I right click on a sheet and select "rename & renumber".  The Rename and Renumber dialog box pops up and I type "1" then click on "next", type "2", "next", and so on.  This continues until the end of the subset, the stops.  Then I have to right click on a sheet in the next subset and start over.

 

I want to renumber the whole plan set without stopping at each subset.  Obviously, I can get rid of the subsets, but that isn't my question.  I want to keep the subsets and have the ability to renumber the whole set.

 

Any ideas?

 

Thank you

*Expert Elite*
Jeff_M
Posts: 4,521
Registered: ‎07-22-2003
Message 2 of 2 (96 Views)

Re: renumber sheet set through sub sets

10-09-2013 06:09 AM in reply to: johnmeyers

If you were open to 3rd party software to aid in this:

http://www.quuxsoft.com/SincpacC3D_Help/SP_SSMRenumber.htm

Jeff_M, also a frequent Swamper
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.