AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Contributor
Habib_Nespak
Posts: 12
Registered: ‎05-04-2013
Message 1 of 3 (192 Views)
Accepted Solution

Proposed and Existing Elevation on a single Point

192 Views, 2 Replies
02-06-2014 02:24 AM

dears

i want to show a two elevation like ground level and proposed level at same point and want to find the difference of elevation.

please help me in this regards

Habib Ahmed

If all you are looking for is "want to find the difference of elevation", then all you need to do is create a "Tin Volume Surface".  A tin volume surface is the difference between two existing surfaces in Prospector. I.E., contour lines will represent the difference between surfaces at any given point.

 

Bill

 

*Expert Elite*
Joe-Bouza
Posts: 5,031
Registered: ‎12-15-2008
Message 2 of 3 (171 Views)

Re: Proposed and Existing Elevation on a single Point

02-06-2014 04:31 AM in reply to: Habib_Nespak
Use a reference component in your label style to pick up the second surface
Thank you

Joseph D. Bouza, P.E. (one of 'THOSE' People) Civil 3D 2012 & 2013
HP Z210 Workstation
Intel Xeon CPU E31240 @ 3.30 Hz
12 GB Ram


Note: Its all Resistentialism, so keep calm and carry on

64 Bit Win7 OS
*Expert Elite*
wfberry
Posts: 1,884
Registered: ‎09-05-2006
Message 3 of 3 (162 Views)

Re: Proposed and Existing Elevation on a single Point

02-06-2014 05:10 AM in reply to: Habib_Nespak

If all you are looking for is "want to find the difference of elevation", then all you need to do is create a "Tin Volume Surface".  A tin volume surface is the difference between two existing surfaces in Prospector. I.E., contour lines will represent the difference between surfaces at any given point.

 

Bill

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.