AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Contributor
jabei
Posts: 13
Registered: ‎08-18-2011
Message 1 of 3 (159 Views)

Profiles

159 Views, 2 Replies
11-25-2011 01:29 PM

Is there a way I can take my finished ground profile in my profile view and get Civil 3d 2011 to label the pvi's in the plan view?

Distinguished Mentor
Civil3DReminders
Posts: 910
Registered: ‎03-24-2009
Message 2 of 3 (145 Views)

Re: Profiles

11-25-2011 10:26 PM in reply to: jabei

Yes, check out the labels for the alignment. There is a label type to do what you are looking for.

 

Christopher

http://blog.civil3dreminders.com/

Mentor
onsionsi1
Posts: 150
Registered: ‎10-19-2011
Message 3 of 3 (144 Views)

Re: Profiles

11-25-2011 10:39 PM in reply to: jabei

Yes, absolutely you can do that.

1- Go to alignment labels.

2- Go to Profile geometry points and select point label style to code and stations and press the down arrow to select an action and press the bottom content as shown below

Alignment Label 1.JPG

 

3-Select the properties (PVI Elevation) and then press the Right arrow bottom to add this content to your label style and eventually you can erase other content or leve it as you want to display.

Alignment Label 2.JPG

Please do not forget approve as solutions and Points
to Remember Please Accept as Solution and Kudos Please
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.