AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Contributor
jabei
Posts: 13
Registered: ‎08-18-2011
Message 1 of 3 (153 Views)

Profiles

153 Views, 2 Replies
11-25-2011 01:29 PM

Is there a way I can take my finished ground profile in my profile view and get Civil 3d 2011 to label the pvi's in the plan view?

Distinguished Mentor
Civil3DReminders
Posts: 910
Registered: ‎03-24-2009
Message 2 of 3 (139 Views)

Re: Profiles

11-25-2011 10:26 PM in reply to: jabei

Yes, check out the labels for the alignment. There is a label type to do what you are looking for.

 

Christopher

http://blog.civil3dreminders.com/

Distinguished Contributor
onsionsi1
Posts: 144
Registered: ‎10-19-2011
Message 3 of 3 (138 Views)

Re: Profiles

11-25-2011 10:39 PM in reply to: jabei

Yes, absolutely you can do that.

1- Go to alignment labels.

2- Go to Profile geometry points and select point label style to code and stations and press the down arrow to select an action and press the bottom content as shown below

Alignment Label 1.JPG

 

3-Select the properties (PVI Elevation) and then press the Right arrow bottom to add this content to your label style and eventually you can erase other content or leve it as you want to display.

Alignment Label 2.JPG

Please do not forget approve as solutions and Points
to Remember Please Accept as Solution and Kudos Please
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.