Community
Civil 3D Forum
Welcome to Autodesk’s Civil 3D Forums. Share your knowledge, ask questions, and explore popular AutoCAD Civil 3D topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Profile View horizontal geometry bands

5 REPLIES 5
Reply
Message 1 of 6
harold.alberto
661 Views, 5 Replies

Profile View horizontal geometry bands

Hi All,

 

I'm using C3D 2012.  I created a profile view for a straight horizontal alignment.  The band label for the horizontal won't appear for this particular straight aligment.  I have a few other alignments that has curves in it and the profile view displays the labels fine.

 

I tried to create a new straight alignment again, create a profile view but I get the same results.

 

I also tried it on a new drawing using the NCS metric template with same results.

 

Has anyone experienced this before?  

 

The only solution I can think of (if this is a bug) is to extend my alignment by say 0.1m and add a new IP at the correct alignment end, mask that on plan and end my profile view to the right length. 

 

Thanks 

Harold

 

 

5 REPLIES 5
Message 2 of 6
Joe-Bouza
in reply to: harold.alberto

It appears to not label the horizontal band if there is only the start and end PI. if I add a PI it give two length labels. I assume the developers felt and alignment with only two PI's was described fully by the stationing?
Thank you

Joseph D. Bouza, P.E. (one of 'THOSE' People)

HP Z210 Workstation
Intel Xeon CPU E31240 @ 3.30 Hz
12 GB Ram


Note: Its all Resistentialism, so keep calm and carry on

64 Bit Win10 OS
Message 3 of 6
harold.alberto
in reply to: Joe-Bouza

Thanks very much Joe.

 

Is it the same on 2013? 

Message 4 of 6
Joe-Bouza
in reply to: harold.alberto

Apparently so. HTH
Thank you

Joseph D. Bouza, P.E. (one of 'THOSE' People)

HP Z210 Workstation
Intel Xeon CPU E31240 @ 3.30 Hz
12 GB Ram


Note: Its all Resistentialism, so keep calm and carry on

64 Bit Win10 OS
Message 5 of 6
harold.alberto
in reply to: Joe-Bouza

Thank you.

 

I understand that the length of the alignment maybe shown on the stationing.  But what about the other alignment properties that may be added to the band like direction, start/end northing and easting, etc.

 

I'm pretty sure it was working on 2010/2011. 

 

 

Message 6 of 6
Joe-Bouza
in reply to: harold.alberto

I hear ya.
Thank you

Joseph D. Bouza, P.E. (one of 'THOSE' People)

HP Z210 Workstation
Intel Xeon CPU E31240 @ 3.30 Hz
12 GB Ram


Note: Its all Resistentialism, so keep calm and carry on

64 Bit Win10 OS

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Rail Community


Autodesk Design & Make Report