AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Contributor
HC1975
Posts: 36
Registered: ‎01-12-2009
Message 1 of 2 (406 Views)

Pressure Pipe Networks: setting Min cover AFTER laying out horizontal design

406 Views, 1 Replies
01-02-2013 01:15 PM

Good afternoon.

 

I created a pressure pipe network but during horizontal design I did not specifiy a minimum cover depth.

 

After completing the horiz design I created a profile.  The network parts all have a centerline elevation of 0.00, which is expected.

 

Now I want to go back and specify the minimum cover but I don't know how.  If I type in 3-ft as part of the Network Properties menu, nothing happens.  And if I click on the "follow surface" button then the pipes and fittings are set at minimum depth but it adds vertices to the pipe parts which I don't want.  I would like only the pipe ends to be used to set the depth.

 

Any suggestions on how the min cover can be set other than to redraw the network with the depth setting set from the beginning?

 

Thanks

*Pro
dgordon
Posts: 1,474
Registered: ‎12-14-2006
Message 2 of 2 (367 Views)

Re: Pressure Pipe Networks: setting Min cover AFTER laying out horizontal desig

01-03-2013 01:57 PM in reply to: HC1975

assign the rules to the pipes and then select the pipes i think one at a time and right click apply rules.

 

 

Dan

Civil 3D 2013
Win 7 Pro x64
Intel Xeon 2.0GHz
12Gb Ram
ATI Firepro 4800
Dell T5500
www.preinnewhof.com
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.