Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
i perform all the stages of setting up a corridor( horzntal alignment, EG profile and lay out profile also from toolpalette I set up sub assemblies) but i receive an 'POINT NOT ON ENTITY ERROR'in the event viewer. How can I solve this problem?? what causes this problem??
Does your corridor start at a station BEFORE the layout profile? If so,
make sure to start the corridor at the exact statino (and end at the end) of
your layout profile.
wrote in message news:5208836@discussion.autodesk.com...
i perform all the stages of setting up a corridor( horzntal alignment, EG
profile and lay out profile also from toolpalette I set up sub assemblies)
but i receive an 'POINT NOT ON ENTITY ERROR'in the event viewer. How can I
solve this problem?? what causes this problem??
I have checked my starting and end stations as you said but I still have the same error message 'point not on entity', can it be caused from by Subassembly( i am making a repeating benches for a pipeline construction). ??? How can I repair that problem???
For what it is worth, most of those "errors" are not of any value and after
looking them over, I just ignore them if everything appears OK.
Bill
wrote in message news:5209923@discussion.autodesk.com...
I have checked my starting and end stations as you said but I still have the
same error message 'point not on entity', can it be caused from by
Subassembly( i am making a repeating benches for a pipeline construction).
??? How can I repair that problem???
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")