AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

New Member
Posts: 2
Registered: ‎11-16-2009
Message 1 of 1 (244 Views)

Plots now have gaps in linework since upgrading to Civil 3d2011

244 Views, 0 Replies
07-06-2011 04:04 PM

My plots have gaps in them however the gaps do impact all linework.  See attached drawings.  1 is with gaps the other is how I would like it to print.


I have civil 3d 2011.  windows 7- 64 bit.   HP Design jet z2100 plotter.  I have the latest drivers and firmware.  I assume the driver has become incompatible but would appreciate any thoughts.


I have tried to adjust the RASTERPERCENT AND RASTERTHRESHOLD settings to no avail.  It will print fine if I create a pdf and  I print the pdf as an image.  If i do not print the pdf as an image or print a dwf I get the same results.



Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.