I have a profile view that shows two ditch profiles in it, for right and left ditch. They are similar in elevation, so they overlap some in the profile view. Is there a way to show one of them at a set interval below its actual datum, like say, 5'? Short of drawing in a dummy profile or expolding it - which I'm going to do shortly....
I've never heard of any way to show a profile at any elevation other than what it actually is.
What you might be able to do is create a profile view style that doesn't show anything, or at least puts things on a no-plot layer. Then put one of the ditch profiles in that profile view and overlay it on top of the original one. Adjust the elevation limits of the no-plot view to shift that profile up or down.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!