Im creating some P&P sheets for a road I have. I have all the information, alignments, surfaces, profiles, etc.
I created View Frames, then Create Aheets. I put all layouts into one new drawing.
When I open the new drawing, the plan comes in fine, profile settings do not transfer, even though I specified that, in the sheets creation, it copy settings from the existing profile in my PLN drawing.
Basically, I have a nice profile layout in my PLN drawing, but when it comes into my P&P sheet, it skyrockets my ht of profile from 40 (in my PLN) to 157 (in P&P).
Pictures attached, if that can help.
I'm running AutoCadd C3D 2012.
Thanks for the help.
Solved! Go to Solution.
Thanks, that was my exact problem! Why doesn't Autodesk ever fix this stuff?
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!