AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Active Contributor
Posts: 33
Registered: ‎05-01-2003
Message 1 of 2 (59 Views)

Pipes - Using Civil Design 2005

59 Views, 1 Replies
08-12-2004 02:00 PM
I have created 2 separate pipe runs; new run and proposed run. I want to connect the end of the propsed run to a point in the existing run. How do I connect it and how do I hold the invert at the connect to the existing?
*Conan Witzel
Message 2 of 2 (59 Views)

Re: Pipes - Using Civil Design 2005

08-13-2004 05:54 AM in reply to: laffa2
You may want to post in the land Desktop forum but: You will need to have a node on the existing run. Then snap the end of the proposed run to the node. You can adjust the invert in the editors, either graphical or db. Hope this helps, conan witzel
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.